Avigilon ENC-4P-H264 |
CathexisVision Camera Integration |
Driver: |
 |
| Datasheet | |
| Unicast | |
| CathexisVision Driver: | Onvif |
| Number Of Channels: | 4 |
| Number Of Streams: | 1 |
| Format: | JPEG/H.264 |
| Transport: | RTP/TCP and RTP/UDP |
| Audio: | Not tested |
| Resolution: |
Primary stream |
| Multicast | |
| Format: | Not tested |
| Audio: | Not tested |
| Resolution: | Not tested |
| I/O | |
| Inputs: | Not tested |
| Outputs: | Not tested |
| Settings | |
| Edge Review: | Not supported |
| PTZ Control: | N/A |
| Cathexis Software: | CathexisVision 2023 SP2 and later |
| Camera Firmware: | 4.38.0.28(5550543b) |
| Notes | |
|
The ENC-4P-H264 4 channel encoder reports that it has 4 outputs and are populated in the setup. The encoder doesn’t support base event notifications, or pull-point events, therefore any state changes for the outputs cannot be received. The encoder does accept the set/pulse/clear commands for the outputs, but this can only be confirmed in the encoders Access/Info log. |
|
| Cathexis Integrations |
