| |
|
| Unicast |
|
| CathexisVision Driver: |
Bosch V2 |
| Number Of Cameras: |
1 |
| Number Of Streams: |
2 |
| Format: |
H.264/JPEG |
| Transport: |
Default, RTP/TCP and RTP/UDP |
| Audio: |
Listen only |
| Resolution: |
2.0MP (1920×1080), 1.3MP (1536×864), 0.9MP (1280×720), 4CIF (704×480), 331kP (768×432), 147kP (512×288) |
| Multicast |
|
| Format |
H.264 |
| Audio |
Yes |
| Resolution |
Stream Dependent |
| |
|
| Camera Triggers |
|
| Trigger messages: |
All listed audio frequency triggers work as well as AUDIO_ENTIRE, FLAMES, GLOBALCHANGE, REFERENCECHECK, SIGNALBRIGHT, SIGNALDARK, SMOKE and STARTMOTION |
| |
|
| I/O |
|
| Inputs: |
2 inputs |
| Outputs: |
1 output |
| |
|
| Settings |
|
| Edge Review: |
Not supported |
| PTZ Control: |
N/A |
| Cathexis Software: |
CathexisVision 2019 SP2 and later |
| Camera Firmware Version |
6.40.0240 (40020640) [updated from 6.30.0136 (36010630)] |
| |
|
| Notes |
|
| |
- The camera works out the encoding interval in fps which may differ from the framerate selected in CathexisVision. This will affect live streaming and recordings.
|
| |
|
| Limitations |
|
| |
- Audio out not supported.
- There is a timestamp issue when audio in is enabled which may be resolved with later firmware. If audio in is required then please use RTP/CATUDP for the best results.
- The camera doesn’t automatically report IO state changes to CathexisVision. It continually needs to be polled for IO states and we do so every 2 seconds by default. Any state change that occurs for less than 2 seconds may not be detected. Set the camera’s output pulse duration in CathexisVision to more than 2000ms to ensure that, when triggered from our software, the output’s state change is detected. Otherwise enable fast IO polling which will poll the camera’s IO states as fast as possible. This may impact camera performance.
|
| |
|
