G4S GID10A |
CathexisVision Camera Integration |
Driver: |
Unicast | |
Number Of Streams : | Default 1, more if video enabled on camera web interface (See setup notes) |
Format : | H264/MJPEG |
Audio : | Listen Only (See setup notes) |
Resolution : | 0.9MP |
Multicast | |
Not Available | |
Motion Detection | |
Not Supported | |
I/O | |
Not Supported | |
Settings | |
Serial Port : | Not Supported |
PTZ Control : | Not Available |
Cathexis Software : | CatVision 2014 and later |
Camera Firmware : | 1.0.3 |
Setup Notes | |
Initial Setup Start the INIT Tool (found on disc), select the camera to be set up, and click on remote setup Click on System -> User/Group Click on Video -> Streaming and then enable the secondary stream The camera is now in a state where it can be added on a 5043b system Be sure to enter the username and password admin admin in the encoder setup page on the NVR Audio Setup Audio must be enabled on the camera web interface – G711u must be selected |
|
Limitations | |
User can only add the CIF resolution at 30fps – all other resolutions are configurable |
Cathexis Integrations |