Pelco Sarix Range

CathexisVision Camera Integration

Number Of Streams : 2
Format : H2642
Audio : Not Supported
Resolution : Stream Dependant
 Format :  H264
  Stream Dependant
Motion Detection  
Trigger String : Motion messages are constructed of the zone name (if present) and the uppercase characters of the analytic function:
< Zone Name >:< Analytic Event > 
E.g. If the AdaptiveMotion is enabled and set the Zone name to “Zone 1” the message trigger will be:
“Zone 1:AM”
If the analytic function does not specify a zone name when set up on the camera, omit . The message trigger
for Sabotage Detection will be: “SB”
If the message trigger is set to “STARTMOTION”, all message triggers from the camera will trigger the event
The zone name NOT be longer than 16 characters.
PTZ Control : Implemented, but has not been tested.
Cathexis Software : 5042d1 and later
Camera Firmware :
Limitations :

    • Due to the complexity of the stream setups, this has to be done by the user via the camera web interface.
    • Please note that only H.264 streaming is supported. 
    • Refer to Pelco Setup for setup notes.
    • Need to set up streams on camera web interface.
    • Please refer to the following page for firmware version 1.9 change notes: Pelco Firmware V1.9

Pelco Camera Integration Guide

Pelco Sarix Spectra Camera Integration App-note.pdfDownload


Cathexis Integrations