Limitations : MxPEG not supported To setup Motion Detection follow steps below: login on to the web interface of the camera. Click on “Setup Menu” Click on “Gerneral Events Settings” Make sure that the arming is enabled. Click on “Set” and “Close” Open “Setup Menu” again and click on “Event Settings” enable video motion window and click on “Add Rectangle” follow the instructions on how to add the zone. Click on “Set” and “Close” Open “Setup Menu” again and click on “Messaging”. Go down to IP Notify (IP) and click on “IP Notify Profiles” Find the Profile named “SimpleNotify” and set the following: IP Notify Type : Custom Configuration Destination Address : IP of NVR with the port 32121 eg:(192.168.3.100:32121) Data Protocol : Raw TCP/IP Data Type : Plain Text $(EVT.EST.ACTIVATED) Click on “Set” and “Close” Open “Setup Menu” again and click on “Messaging”. Go down to IP Notify (IP) and select “SimpleNotify”. On Catsite in the camera setup on the I/O tab you will be able to setup a tigger for VM.