Pelco Exsite IP Fixed |
Integration
CathexisVision Version: Pre 2014
Firmware: 1.6.13.9080-A1.4657
Tested: No
License: Implemented, but has not been tested.
Image
Technology Partner
Pelco
Description
Limitations :
Due to the complexity of the stream setups, this has to be done by the user via the camera web interface.
Please note that only H.264 streaming is supported.
Refer to Pelco Setup for setup notes.
Need to set up streams on camera web interface.
Please refer to the following page for firmware version 1.9 change notes: Pelco Firmware V1.9
Pelco Camera Web Configuration for Cathexis H264 Integration
Camera Details
Type:
Camera
Camera
Channels:
1
1
Streams:
2
2
Protocol:
Native
Native
Multicast:
No
No
Audio:
Not avaliable
Not avaliable
Edge Insertion:
No
No
VMD:
No
No
Transport:
RTP/TCP
RTP/UDP
Codex:
MPEG-4
H264
Edge Review:
No
No
Resolution: 704 x 576
Camera Events
Motion Detection
Trigger String : Motion messages are constructed of the zone name (if present) and the uppercase characters of the analytic function:
:
E.g. If the AdaptiveMotion is enabled and set the Zone name to “Zone 1” the message trigger will be:
“Zone 1:AM”
If the analytic function does not specify a zone name when set up on the camera, omit . The message trigger
for Sabotage Detection will be: “SB”
If the message trigger is set to “STARTMOTION”, all message triggers from the camera will trigger the event
The zone name NOT be longer than 16 characters.
