Pelco Exsite IP PTZ |
Integration
CathexisVision Version: Pre 2014
Firmware: 1.6.13.9080-A1.4657
Tested: No
Image
Technology Partner
Pelco
Documents
 |
Pelco camera | |||||
|
||||||
Description
Limitations :
Due to the complexity of the stream setups, this has to be done by the user via the camera web interface.
Please note that only H.264 streaming is supported.
Refer to Pelco Setup for setup notes.
Need to set up streams on camera web interface.
Please refer to the following page for firmware version 1.9 change notes: Pelco Firmware V1.9
Camera Details
Type:
PTZ
PTZ
Channels:
1
1
Streams:
2
2
Protocol:
Native
Native
Multicast:
No
No
Audio:
Not avaliable
Not avaliable
Edge Insertion:
No
No
VMD:
No
No
Transport:
RTP/TCP
RTP/UDP
Codex:
MPEG-4
H264
PTZ Control:
Implemented, but has not been tested.
Implemented, but has not been tested.
Edge Review:
No
No
Resolution: 704 x 576
Camera Events
Motion Detection
Trigger String : Motion messages are constructed of the zone name (if present) and the uppercase characters of the analytic function:
:
E.g. If the AdaptiveMotion is enabled and set the Zone name to “Zone 1” the message trigger will be:
“Zone 1:AM”
If the analytic function does not specify a zone name when set up on the camera, omit . The message trigger
for Sabotage Detection will be: “SB”
If the message trigger is set to “STARTMOTION”, all message triggers from the camera will trigger the event
The zone name NOT be longer than 16 characters.
